Soooooooo I just got my oem sensors in the mail today and they dont seal tight against the valve stem hole on my new aftermarket wheels (ag m310). In the pic below you can see the gap between the rubber grommet and the washer/nut that goes on the outside of the wheel. That gap is too big and the nut is as tight as it gets in the pic. My question is... Can I just use a washer on the outside part of the wheel to get it to seal tight since the actual sealing surface of the rubber grommet is on the inside? So it shouldnt cause any issue with holding air? Im pretty sure I got the correct oem sensor #06421-S3V-A04. I am supposed to get my tires mounted monday so I need to figure out how to fix this asap :whyme:
![]()
![]()
