Hello all,
I have a 2003 Acura TL and have been installing LED exterior lights. i have installed 4 (two on each side) LED tail/stop lights. After installation, the "brake light" indicator on the dash is continually lit up. I suspect due to the less power draw of the LED lights. Today I installed four LED 50W, 6 Ohm load resistors (1 for each LED light), attempting to remedy the annoying dash light. The tail light sockets have three wires going to them, Black, Green/Yellow stripe, and Red/Black stripe. I am assuming that I will attach one side of the load resistor to the Black wire (correct?). What is the correct color wire to attach the other side of the LED load resistor?
Thank you for your assistance.
I have a 2003 Acura TL and have been installing LED exterior lights. i have installed 4 (two on each side) LED tail/stop lights. After installation, the "brake light" indicator on the dash is continually lit up. I suspect due to the less power draw of the LED lights. Today I installed four LED 50W, 6 Ohm load resistors (1 for each LED light), attempting to remedy the annoying dash light. The tail light sockets have three wires going to them, Black, Green/Yellow stripe, and Red/Black stripe. I am assuming that I will attach one side of the load resistor to the Black wire (correct?). What is the correct color wire to attach the other side of the LED load resistor?
Thank you for your assistance.