As you know, the dash could be somewhat of a bear to remove and reinstall to get the sensor all the way at the front of the dash.. So, I fond a new place and after dremeling, it snapped perfectly and very firmly into place.. Like I knew what I was doing!! The secret is to dremel slowly, just a little at a time. And snap! into position it went! So, All I have done is mount the sensor. But I have the remaining components and the schematics to finish. By the way... if you do electrical mods and do not have all the connectors, you gotta get some of these little jumper wires from FRY's. They come in male to female and female to female and I think male to male. And even these jumpers are super firm mounted on the sensor. They are not coming off!
![Click the image to open in full size.]()
![Click the image to open in full size.]()
![Click the image to open in full size.]()
